Clarion ProSecurity RK20 Guia de Instalação descarregar pdf (Página 25)

Remove the two 30-amp fuses prior to connecting these wires and do not re-

place them until the satellite has been plugged into the control module. These

wires are the source of current for pink ignition, orange accessory, purple starter,

and the coils for the relays in the relay pack. They must be connected to a high

current source. Since the factory supplies (+)12V to the key switch that is used to

operate the motor, it is recommended that these wires be connected there.

Note: If the factory supplies two separate (+) 12V feeds to the ignition switch,

connect one RED wire of the satellite to each feed at the switch.

➤ Program switch - 2-pin connector

The program switch plugs into the blue two-pin connectors

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 55 56

Sem comentários

Clarion ProSecurity RK20 Guia de Instalação Página 25