Clarion ProSecurity RK20 Guia de Instalação descarregar pdf (Página 18)

Wire connection guides

➤ Primary harness (H1), 9-pin connector

H1/1

LIGHT GREEN/

BLACK

(-) FACTORY ALARM DISARM

Relay for Negative (-)

Disarm Wire

Relay for Positive (+)

Disarm Wire

H1/2

GREEN/WHITE FACTORY ALARM REARM OUTPUT

This wire sends a negative pulse every time the remote start shuts down or when

the doors are locked. This can be used to pulse the arm wire of the vehicle’s fac-

tory anti-theft device. Use a relay to send a (-) or (+) pulse to the arm wire.

H1/3

YELLOW (+) IGNITION OUTPUT

As a stand-alone system: The H1/3 YELLOW wire should not be connected to

anything and taped off.

As an add-on car starter: If connected, disconnect the ignition/accessory input

of the remote controlled security or keyless entry system. Connect the H1/3

YELLOW ignition output to the ignition/accessory input of the remote controlled

security or keyless entry system. The wire will prevent the host system from sens-

ing that the ignition is on during remote engine start operation.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 55 56

Sem comentários

Clarion ProSecurity RK20 Guia de Instalação Página 18