Clarion ProSecurity RK20 Guia de Instalação descarregar pdf (Página 19)

Most vehicles use negative door trigger circuits. Connect the green wire to a wire which shows ground when any

door is opened. In vehicles with factory delays on the domelight circuit, there is usually a wire that is unaffected

by the delay circuitry. This wire will report Zone 3.

Connect this wire to the optional domelight supervision relay as shown below:

IMPORTANT! This output is only intended to drive a relay. It cannot be connected directly to the

domelight circuit, as the output cannot support the current draw of one or more light bulbs.

This input comes from the factory set to 2 activation pulses. This means that it is necessary to have 2 consecu-

tive ground pulses on the white/blue wire for the remote start to activate or to deactivate. The same holds true

for the remote control activation when set to a two pulse setting it is necessary to press the button twice

for the remote start to activate or deactivate.

NOTE: When the activation pulse count can be programmed to 1, 2, or 3 pulses when changed it

will affect both activation inputs; the White/Blue wire and the remote control activation.

H1/10 WHITE/BLUE remote start (-) activation input

H1/9 BLACK/WHITE (-) 200 mA domelight supervision output

H1/8 GREEN (-) door trigger input, zone 3

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 59 60

Sem comentários

Clarion ProSecurity RK20 Guia de Instalação Página 19