Clarion DVC920 Manual do Utilizador descarregar pdf (Página 11)

280-7804-00

DVC920 15

Precautions Regarding Wiring

[STAND-ALONE / SLAVE] switch

• Set the [STAND-ALONE / SLAVE] switch to

the [STAND-ALONE] position.

• The factory default setting is the [SLAVE]

position.

CAUTION:

When setting the position of the [STAND-ALONE /

SLAVE] switch, first confirm that the 5.1ch surround

decoder’s CeNET cable or power connector are dis-

connected, then use a plastic stick to move the

switch to the desired position. Also, in order to pre-

vent damage to the switch or the possibility of short-

circuit accidents, do not use metal objects, or large

screwdrivers to change the switch position.

Control Unit cord

• Insert the control unit cord firmly until it locks

securely.

• Connect the L-type plug to the decoder. The

unit will not operate if the plugs are con-

nected in reverse.

Power cord

• Remove the power connector label, and with

the connector facing in the position shown,

insert the cable connector securely into the

slot until it locks.

Note:

• The power cable must be connected.

RCA Pin Cable (sold separately)

• When connecting an RCA pin cable, be sure

to confirm the source of the connection first.

CeNET Cable

• To connect a CeNET cable, hold it with the

connector facing as shown, and insert se-

curely.

Optical Digital Cable (sold separately)

• Insert the black connector securely into the

digital signal input connector until it locks.

The cable clip can be used to secure up to

two optical digital cables.

Note:

• Always turn the main [POWER] switch [OFF]

before connecting or disconnecting digital fiber-

optic cables.

[RESET] switch

• Following completion of wiring, press the

[RESET] switch to return to default settings.

[STAND-ALONE / SLAVE]

switch

Be sure to set switch to [STAND-ALONE] po-

sition.

Label

Power cable

CeNET input connector

CeNET cable

Sliding cap

Optical Digital cable

(black connection)

Cable clip

280-7804-00_09-18(En) 2/22/02, 2:07 PM15

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 67 68

Comentários a estes Manuais

Sem comentários

Clarion DVC920 Manual do Utilizador Página 11

Comentários a estes Manuais