Clarion MCD360 Manual do Utilizador

2-Way System Application NotesAfter all the wiring connections are made and before the system is turned onfor the first time, you need to make some ba

Setting the Rear Output LevelBefore setting rear level controls, disconnect both the front output and thesubwoofer output and follow the directions be

3-Way System12Figure 6 - In this illustration, the MCD360 is configured for single channelinput with dedicated amplifiers for tweeters, midranges and

3-Way System Application NotesAfter all the wiring connections are made and before the system is turned onfor the first time, you need to make some ba

Setting the Sub Output Level1. Make sure all ouputs are connected and both the front and rear outputlevels are set correctly. Unplug the Remote Sub Le

Problem:Midrange speakers “pop” with loud passages.Solution:High-Pass Frequency Control is set too low.Gain Controls on amplifiers are set incorrectly

661 W. Redondo Beach Blvd.Gardena, CA 902471-800-GO-CLARIONwww.clarion-usa.comMCD360-10 Rev.1 (02/00)

INTRODUCTIONThe Clarion MCD360 is a full-featured Three-Way Crossover. When used tobuild a 2-way system with front and rear fader capability or a full

INPUT/OUTPUT CONNECTIONS AND AUDIO CONTROLSThe top panel of MCD360 contains the controls for the crossover and outputlevels as shown below.31. Front R

• Front High-Pass Crossover Frequency Adjustment - Adjusts the crossoverto match your speaker system. The crossover frequency can be adjusted from32Hz

MOUNTING PRECAUTIONS The MCD360 crossover can be mounted in any convenient location in yourvehicle that allows access to the controls and is away from

WIRING PRECAUTIONSRead all wiring precautions. If you are not sure of the connections, contactyour authorized Clarion dealer.If you are using a source

7Figure 3 - Electrical connections for the MCD-360

APPLICATIONSThe MCD360 allows you to design either a 2-way system with front and rearoutput or a full 3-way system. After determining which system bes

9For 2 channel input,configure switches asshown.For 4 channel inputwith front and rearfade, configureswitches as shown.For front and rear fadewith ded